Leather cleaner & impregnation set

1. Make sure the leather is free of coarse dirt such as sand and mud, for example first rinse it with water and a soft brush.
   
2. Shake the aerosol well before using it, preferably outside or in a very well-ventilated place. After all, you are working with an aerosol.
3. Work in steps, divide your leather jacket or pants in 4 parts to get the best result and prevent drying. For example, do the back of your jacket first, then the front and then the sleeves.
4. Spray the suit & helmet cleaner on the leather and let it sit for a maximum of 25 seconds, then immediately start cleaning with the P.U. cleaning cloth. The suit & helmet cleaner should not be left on the leather for more than 25 seconds.
5. When you are finished with your jacket, pants, saddle or bag, you should rinse it with water. The residue and dirt you should properly drain with water for best results.
6. Then let the leather dry in a normal way, preferably not near a strong heat source such as a stove and not in the sun.
7. To keep the leather in top condition, you can impregnate it afterwards, use our leather impregnator.

1. Make sure the leather is clean and dry before using leather impregnation.
   
2. Shake the spray can well before use. Only use leather impregnation outside or in a very well-ventilated place. After all, you are working with an aerosol.
   
3. Work in steps, for example divide a jacket or pair of trousers into 4 parts to achieve the best result and prevent them from drying out. For example, first do the back of your jacket, then the front and then the sleeves.
   
4. Spray the leather impregnation on your suit, rather a little too little than too much. You can immediately buff out the product with an old cotton cloth or T-shirt.

Cleaning the lining of your helmet

1. Make sure your helmet is firmly upside down, for example on a towel or pillow.
2. Shake the aerosol well before using it, preferably outside or in a very well-ventilated place. After all, you are working with an aerosol.
3. Remove your visor or cover it well before you start. The suit & helmet cleaner must not get onto your visor.
4. Spray the suit & helmet cleaner on the helmet liner and polish off the dirt with a cloth or soft brush.
5. When the foam has dried reasonably well you can vacuum your lining with a vacuum cleaner. This will remove the loose dirt.
6. For the best result you can clean your lining with a damp cloth. If your helmet is very dirty, you can repeat the above process.